rebuilt 390 value?

[Jared]

Hello,

I'm looking to place a price on my rebuilt 390 engine but I only have a rough idea. I had it professionally rebuilt at a machine shop in Nashua, NH 8 yrs ago with the intent of putting it back into my fathers 68"AMX. Now I'm thinking of selling it.
It's been kept on an engine stand inside a garage. I turn the crank every couple months and always keep a little oil in the cylinders. I live in NH. Below is a list of the work I had done as well as the new parts I bought. The engine has NEVER been started and I have receipts and boxes for everything, including instructions.

Any help on the value and a realistic price to ask would be greatly appreciated. THANKS.

Engine kit
New Rockers, springs, conn. rods & valves
8 Plugs
Bored block .030
Turned crank
Hot tanked block
8 Hard exhaust seats
Valve job
Decked heads
Installed Mallory elect. dist.
8 pistons
------------------------------$1,969.00

Edlebrock Thunder Series Carb. 1806 650 CFM AVS Electric choke.....$367.95
Edlebrock Performer RPM Air Gap Aluminum Manifold 7530......$272.95
New Cam Shaft that came as a kit with the Carb. and Manifold from Summit.....$185.95
Mallory Unilite Distributor.......$289.95
Resistor....$14.88
Power Filter.....$33.88
High output coil.....$34.88
Water pump & Thermostat....$
Alternator.....$85.18
Fuel pump.....$73.28
-------------------------------$1,358.90 TOTAL......$3,327.9

[Big Bad AMX]

Hello,

I'm looking to place a price on my rebuilt 390 engine but I only have a rough idea. I had it professionally rebuilt at a machine shop in Nashua, NH 8 yrs ago with the intent of putting it back into my fathers 68"AMX. Now I'm thinking of selling it.
It's been kept on an engine stand inside a garage. I turn the crank every couple months and always keep a little oil in the cylinders. I live in NH. Below is a list of the work I had done as well as the new parts I bought. The engine has NEVER been started and I have receipts and boxes for everything, including instructions.

Any help on the value and a realistic price to ask would be greatly appreciated. THANKS.

Engine kit
New Rockers, springs, conn. rods & valves
8 Plugs
Bored block .030
Turned crank
Hot tanked block
8 Hard exhaust seats
Valve job
Decked heads
Installed Mallory elect. dist.
8 pistons
------------------------------$1,969.00

Edlebrock Thunder Series Carb. 1806 650 CFM AVS Electric choke.....$367.95
Edlebrock Performer RPM Air Gap Aluminum Manifold 7530......$272.95
New Cam Shaft that came as a kit with the Carb. and Manifold from Summit.....$185.95
Mallory Unilite Distributor.......$289.95
Resistor....$14.88
Power Filter.....$33.88
High output coil.....$34.88
Water pump & Thermostat....$
Alternator.....$85.18
Fuel pump.....$73.28
-------------------------------$1,358.90 TOTAL......$3,327.9
+ the block, I'd start around 4k, you can always come down.

[Jared]

Thanks for your response and input.